Re: ITB Conversion on 16 valve 4AGE i found my engine used a shitload additional gas if the o2 sensor was defective/disconnected/etcetera? i wouldnt say they make small variation

flowisode_zero wrote:Silvertops do have Those people connections under the throttles. Blacktops tend not to. So to the BT some thing like this should be employed:

It absolutely was effortless all I had to do is place my engine facts in and they despatched me a e mail rapid. very good costumer service

Your lately viewed products and featured tips › View or edit your searching record Just after viewing product element web pages, seem listed here to seek out a straightforward strategy to navigate back again to pages you have an interest in. Back again to best

Having my JDM Engine 4AGE Blacktop engine from right here was manufactured very simple and worry no cost, would use again if I had to.

Your internet site is straightforward and fast to work with for us outdated geezers who don’t like desktops to start with. Many thanks for retaining it uncomplicated.

Slightly throttle to fifty percent throttle is not any challenge and will not likely give vibrations btw. I am executing 28 mpg max now with straightforward driving and sometimes reving to max 7k, but only in some cases!

I found the comparison by model and price very useful and was in a position to locate the engine I wanted quickly . The internet site is easy to comply with and very well laid out ,saved lots of driving around and time .

The top mounted intercooler will suit underneath the Typically aspirated MR2 hood and will need a hood scoop on FWD Corollas (but a front mount intercooler remains the very best set-up. The bigger (fourteen psi) crank pulley is a must.

So I have adjusted them all plus the vibrations are a little a lot less and the engine feels a ittle bit far more responsive, although not a huge variation. But which is another item i can delete through the listing with possible triggers of creating my car or truck functioning rich.

Northwest Motors is definitely the most beneficial engine house I’ve at any time done company with. I’ve owned close to a hundred engines and bought or rebuilt the engines in almost half of them.

I took the first silvertop manifold and hacked the crap outside of it, I Slash The complete ISCV ports off the best and commenced rounding the runners until eventually I bought to this.

For patrons by having an SQ Engineering 20V to BEAMS adapter plate, be sure to obtain the specialised "3SGE" solution!

Have you gone through the BGBs troubleshooting guide to your signs? Back again firing isn't always that you are managing rich. It could be any here quantity of factors including working lean.